JennAir Microwave Error Code
The turntable motor is not turning or is not receiving a drive signal. The glass tray will not rotate, causing uneven heating. Verify the turntable ring and glass tray are seated correctly and can rotate freely. If the motor has failed, it is a relatively low-cost part but should be installed by a technician.
Note the exact error code and any symptoms
Power cycle — unplug for 60 seconds
Follow the diagnosis steps below
If code persists, call a technician
The turntable motor is not turning or is not receiving a drive signal. The glass tray will not rotate, causing uneven heating. Verify the turntable ring and glass tray are seated correctly and can rotate freely. If the motor has failed, it is a relatively low-cost part but should be installed by a technician.
When your JennAir Microwave displays the F4-E1 code, it means the appliance's self-diagnostic system has detected a fault that requires attention. A single power cycle that clears the code is not a reliable fix if the underlying cause has not been addressed.
Based on our technicians' experience servicing JennAir Microwaves, the F4-E1 code is most frequently triggered by:
Before scheduling a service call, work through these steps in order:
If the F4-E1 code returns after completing the steps above, a component has likely failed. Continuing to run the appliance with an active fault may cause secondary damage.
JennAir Support Center technicians carry the most common replacement parts on every service vehicle. In most cases, we diagnose and complete the repair in a single visit.
Typical ranges based on our service history:
All repairs include a 30 day parts and labor warranty. A written estimate is provided before any work begins.
Error Code Directory
Complete list with diagnosis guides.
| Code | Meaning | Severity | Symptom |
|---|---|---|---|
| F1-E1 | F1-E1 – Microwave Control Board Error | High | The main control board in the microwave has detected an internal fault.... |
| F2-E0 | F2-E0 – Keypad / Touch Panel Shorted | Medium | A key or touch area on the microwave control panel is registering... |
| F3-E1 | F3-E1 – Humidity Sensor Error | Medium | The humidity sensor (used for sensor cooking and sensor reheat modes) is... |
| F5-E1 | F5-E1 – Door Switch Interlock Error | Critical | One or more of the door safety interlock switches has failed. The... |
| F7-E1 | F7-E1 – Magnetron Relay Error | High | The relay controlling the magnetron high-voltage circuit has failed or is not... |
FAQ
Not seeing your specific issue? A two-minute phone diagnosis usually narrows it down.
Call (800) 555-0190A JennAir microwave that runs but doesn't heat has almost certainly suffered a magnetron failure, a blown high-voltage diode, or a failed capacitor. Microwave capacitors store lethal charge even when unplugged — never open a microwave yourself. Our technicians safely discharge and test all high-voltage components.
Noise from a JennAir over-the-range microwave can come from a worn turntable motor, a failing stirrer motor, or a loose ventilation fan blade. A buzzing sound during cooking (without heating) usually indicates a faulty magnetron — this requires professional replacement.
Yes. JennAir microwave drawers are fully serviceable. Common issues include drawer track misalignment, a failed touch control panel, magnetron failure, or door sensor faults. All components are available as genuine JennAir OEM replacement parts.
Book Your Repair
Factory-trained technicians. Genuine OEM parts. 30 day warranty. Most appointments confirmed within 2 hours.
We'll confirm within 2 hours
Schedule Service
Same-day service available. Factory-trained technicians. Genuine OEM parts. 30 day warranty on every repair.