Filter – Grease Filter Cleaning Reminder

What Does the JennAir Filter Error Code Mean?

The filter indicator light is illuminated, signaling that the grease filters are due for cleaning. JennAir recommends cleaning baffle or mesh grease filters every 30 hours of use. Remove the filters and wash them in hot soapy water or run through a dishwasher cycle. After reinstalling, press and hold the filter reset button for 3 seconds.

When your JennAir Ventilation displays the Filter code, it means the appliance's self-diagnostic system has detected a fault that requires attention. A single power cycle that clears the code is not a reliable fix if the underlying cause has not been addressed.

Common Causes of the Filter Error

Based on our technicians' experience servicing JennAir Ventilations, the Filter code is most frequently triggered by:

• Component failure: A worn or failed internal part — motor, pump, sensor, or control board — is the most common root cause when this code appears repeatedly.
• Blockage or restriction: Debris, lint, or mineral buildup in filters, hoses, or drain paths can trigger this error without any component failure.
• Wiring or connector issue: Vibration over time can loosen harness connectors, causing intermittent faults.
• Control board fault: Less commonly, the main control board may misread sensor signals and generate a false error.
• Installation issue: Improper leveling, restricted ventilation, or incorrect water supply pressure can cause error codes under normal operation.

Step-by-Step Troubleshooting

Before scheduling a service call, work through these steps in order:

1. Power cycle the appliance. Unplug from the wall outlet and leave unplugged for 60 seconds. Plug back in and run a short test cycle.
2. Inspect and clean filters. Locate the filter or trap for your specific model. Remove, rinse, and reinstall.
3. Check hoses and connections. Inspect drain hose, water inlet hose, and any visible connections for kinks, blockages, or loose fittings.
4. Verify installation conditions. Confirm the appliance is level, has adequate ventilation clearance, and water supply pressure is within spec.
5. Run a diagnostic cycle. Many JennAir models support a built-in diagnostic mode. Consult your owner's manual for the key sequence.

When to Call a Professional

If the Filter code returns after completing the steps above, a component has likely failed. Continuing to run the appliance with an active fault may cause secondary damage.

JennAir Support Center technicians carry the most common replacement parts on every service vehicle. In most cases, we diagnose and complete the repair in a single visit.

Repair Cost Estimate

Typical ranges based on our service history:

• Blockage removal / filter cleaning: Covered under the diagnostic fee if no part is needed
• Pump or motor replacement: $150-$350 including parts and labor
• Sensor or harness repair: $100-$220 including parts and labor
• Control board replacement: $200-$450 including parts and labor

All repairs include a 30 day parts and labor warranty. A written estimate is provided before any work begins.